Oon, CS and Ateeq, M and Shaw, A and Al-Shamma’a, A and Kazi, SN and Badarudin, A (2016) Experimental study on a feasibility of using electromagnetic wave cylindrical cavity sensor to monitor the percentage of water fraction in a two phase system. Sensors and Actuators A: Physical, 245. pp. 140-149. ISSN 0924-4247
Experimental study on a feasibility of using electromagnetic wave cylindrical cavity sensor to monitor the percentage of water fraction in a two phase system.pdf - Accepted Version
Restricted to Repository staff only until 4 May 2018.
Available under License Creative Commons Attribution Non-commercial No Derivatives.
This study proposed a microwave sensor system to monitor single and two phase flow systems. The microwave sensing technology in this study utilises the resonant frequencies that occur in a cylindrical cavity and monitor the changes in the permittivity of the measured phases to differentiate between the volume fractions of air, water and oil. The sensor system used two port configuration S21 (acted as transmitter and receiver) to detect the fluids inside the pipe. In principle, the strong polarity of water molecules results in higher permittivity in comparison to other materials. A tiny change of water fraction will cause a significant frequency shift. Electromagnetic waves in the range of 5 GHz to 5.7 GHz have been used to analyse a two phase air-water and oil-water stratified flow in a pipeline. The results demonstrated the potential of a microwave sensing technique to be used for the two phase systems monitoring. A significant shift in the frequency and change in the amplitude clearly shows the percentage fraction change of water in the pipe. The temperature study of water also demonstrated the independence of microwave analysis technique to the temperature change. This is accounted to overlapping modes negating the affect. Statistical analysis of the amplitude data for two phase systems shows a linear relationship of the change in water percentage to the amplitude. The electromagnetic wave cavity sensor successfully detected the change in the water fraction inside the pipe between 0-100%. The results show that the technique can be developed further to reduce the anomalies in the existing microwave sensor.
|Uncontrolled Keywords:||0906 Electrical And Electronic Engineering, 0912 Materials Engineering, 0913 Mechanical Engineering|
|Subjects:||T Technology > TD Environmental technology. Sanitary engineering|
|Date Deposited:||18 May 2016 11:35|
|Last Modified:||03 Aug 2016 08:15|
|DOI or Identification number:||10.1016/j.sna.2016.05.005|
Actions (login required)